What to do to repair your Pond Manually?

If you have pond then you know what the frustration of leaky pond is. Or sometime you become as fade up that start thinking to finish it. Better way is to find the solution. The surest, but most expensive and time consuming, method is to drain the pond and repair. Your pond surface needs to be clean, dry and structurally sound. A medium bristle brush and water is all that is needed. You want the surface to be clean of any dirt that will be picked up with the nap of the roller or in the paint brush used during the application process. Finally, the simplest but certain way to seal a leaky pond is use of liner as Pond Repair. The generally recommended liner of Pond Repair must have of quality to last long and repair without harming the water life but it does not mean that you have to buy two products. Less costly Pond Repair of EPDM is the most effective synthetic aquatic products. Pond Repair is to keep water clean and a better technique to utilize to seal pond. Just mix the product with drill and apply its one coat only. It is really as simple as ABC. Let it be dry and then forget your pond leaks for years. Repair Pond is both UV and ozone resistant. It starts its curing process immediately after applying. 

Repair your Pond Manually 

Necessary to remember when you repair your Pond Manually

1. On a Pond that has not been coated with other coatings, it is simply a one coat application of Pond Repair. Any loose caulking needs to first be removed and replaced with either butyl or acrylic caulk.

2. Remove loose portions of existing coatings with a scraper and wire brush.

3. Whatever coatings still have good adhesion may remain and coated with the Pond Repair.

4. Tightly adhering corrosion may be directly coated with Pond Repair.

5. Mixing process must be done by with drill.

The most effective method of application

For Pond Repair notice adequate space after opening the container to add the bottle of catalyst and mix the material in the same can. A drill and a gallon mixer attachment are needed for this. Each bottle of catalyst is contained in the gallon box. When mixing, be sure that the drill is creating a vortex and that the material is mixed for a good 4-5 minutes. During the mixing, bring the drill up and down and also in a circular motion so that the material is all distributed uniformly. The most effective method of application is by a combination of brush, roller or squeegee. For Pond Repair can tolerate extreme temperatures as low as forty degrees below zero and waterproofs immediately after it has been applied. After 5 days above 50 degrees you can fill you pond with water.